User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 370 System Manual
If you use this command to specify a new profile, the configuration mode for the
newly created profile is automatically enabled, after which you can configure the
profile’s filtering rules (refer to “Configuring Hot-Lining Filter Rules” on page 372)
or delete filter rules (refer to “Deleting Filter Rules” on page 378.
You can then terminate the hot-lining profile configuration mode (refer to
“Terminating the Profile Configuration Mode” on page 379) and return to the
global configuration mode.
3.4.12.13.2.2 Enabling/Disabling the Profile
After enabling the hot-lining profile configuration mode, run the following
command to enable/disable the profile:
npu(config-hotlining-profile)# set profile { enabled | disabled }
Command
Syntax
npu(config)# hotlining-profile <profilename>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
profilename Denotes the name of the
hot-lining profile for which the
configuration mode is to be
enabled. Must be unique per
BTS.
If you are creating a new
hot-lining profile, specify the
name of the new profile. The
configuration mode is
automatically enabled for the
new profile.
Mandatory N/A String (1 to 30
characters)
Command
Modes
Global configuration mode
Command
Syntax
npu(config-hotlining-profile)# set profile { enabled | disabled }