User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 369 System Manual
npu(config)# no hotlining-enable
3.4.12.13.2 Managing Hot-Lining Profiles
Up to 10 hot-lining profiles can be defined. Each profile can include up to 16 filter
rules and (if applicable) an HTTP-redirect URL. To manage hot-lining profiles, first
enable the configuration mode for the profile (refer to “Enabling the Profile
Configuration Mode\ Creating a New Profile” on page 369). You can then execute
the following:
 “Enabling/Disabling the Profile” on page 370
 “Configuring the HTTP Redirect URL for the Profile” on page 371
 “Configuring Hot-Lining Filter Rules” on page 372
 “Deleting Filter Rules” on page 378
 “Terminating the Profile Configuration Mode” on page 379
3.4.12.13.2.1 Enabling the Profile Configuration Mode\ Creating a New Profile
To configure the parameters for a hot-lining profile, first enable the hot-lining
profile configuration mode. Run the following command to enable the hot-lining
profile configuration mode. You can also use this command to create a new
profile.
npu(config)# hotlining-profile <profilename>
IMPORTANT
The unit must be reset after enabling/disabling hot-lining.
Command
Syntax
npu(config)# config hotlining-enable
npu(config)# no hotlining-enable
Privilege
Level
10
Command
Modes
Global configuration mode