User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 261 System Manual
3.4.12.8.4 Terminating a Service Interface Configuration Mode
This section describes the commands for:
 “Terminating the IP-IP Service Interface Configuration Mode” on page 261
 “Terminating the VLAN Service Interface Configuration Mode” on page 262
 “Terminating the QinQ Service Interface Configuration Mode” on page 262
3.4.12.8.4.1 Terminating the IP-IP Service Interface Configuration Mode
Run the following command to terminate the IP-IP service interface configuration
mode:
npu(config-srvcif-ipip)# exit
NOTE
Refer to Section 3.4.12.8.2.1 for a description and default value of this parameter.
Command
Syntax
npu(
config-srvcif-ipip)# no tunnel [chksm]
Privilege
Level
10
Command
Modes
IP-IP Service Interface configuration mode
Command
Syntax
npu(config-srvcif-ipip)# exit
Privilege
Level
10
Command
Modes
IP-IP Service interface configuration mode