User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 368 System Manual
application/removal are relevant RADIUS messages from the AAA server. Filter's
action on traffic shall be one of the following: pass, drop, or HTTP-redirect the
traffic. The ASN-GW shall apply the pre-configured profile according to the
Hotline-Profile-ID as delivered from the AAA server.
If filtering is applied, uplink subscriber's packet that does not match any
UL-filter-rule shall be dropped. Downlink subscriber's packet that does not match
any DL-filter-rule shall be dropped.
DHCP traffic in UL and DL direction is always passed.
Anti-spoofing function filtering of UL traffic is performed before the hot-lining
filtering.
Hot-Lining is not applied on an MS with VLAN or Ethernet Services. If the
ASN-GW receives Access-Accept message, which includes any Hot-Lining
attributes, and the subject MS is granted at least one flow with CS-type of VLAN
or Ethernet, the ASN-GW shall initiate De-registration of the MS.
Hot-Lining is supported only for IP-CS services using IP-in-IP tunnel or VLAN
interface connectivity towards the CSN.
When Hot-Lining is disabled in ASN-GW, it shall not include Hot-Lining
Capabilities attributes in any Access-Request messages. If AAA replies with
Access-Accept message which includes any Hot-Lining attributes, ASN-GW shall
initiate De-registration of the MS.
The following sections describe the following tasks:
 “Enabling/Disabling the Hot-Lining Feature” on page 368
 “Managing Hot-Lining Profiles” on page 369
 “Deleting Hot-Lining Profiles” on page 379
 “Displaying Configuration Information for Hot-Lining Profiles” on page 380
 “Displaying the Status of the Hot-Lining Feature” on page 381
3.4.12.13.1 Enabling/Disabling the Hot-Lining Feature
To enable the hot-lining feature, run the following command:
npu(config)# config hotlining-enable
To disable hot-lining, run the following command: