User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 365 System Manual
3.4.12.12.3 Terminating the PHS Rules Configuration Mode
Run the following command to terminate the PHS rules configuration mode:
npu(config-phsrule)# exit
[mask <value>] Indicates the PHSM, which
contains the bit-mask of the
PHSF with the bits set that is
to be suppressed.
Mandatory N/A String This
parameter is of
format
"0x000000".
Here Octet(x),
x=3 bytes,
each Byte will
represent two
characters
when used as
string like in
xml file.
[verify <value>] Indicates whether the PHS
header is to be verified.
Optional 0 (No)
 0: Indicates
that the
PHS
header
should not
be verified.
 1: Indicates
that the
PHS
header
should be
verified.
[size <value>] Indicates the size in bytes of
the header to be suppressed.
Mandatory N/A 0-20
Command
Modes
PHS rules configuration mode
Command
Syntax
npu(config-phsrule)# exit
Privilege
Level
10
Command
Modes
PHS rules configuration mode