User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 359 System Manual
3.4.12.11.4.11Clearing the configuration of the L2 Classification Rule
Run the following command to clear the configuration of this classification rule
(removing the configured cvid):
npu(config-clsfrule-L2)# no cvid
After clearing the configuration you can define a new cvid for this classification
rule.
3.4.12.11.4.12Terminating the L2 Classification Rule Configuration Mode
Run the following command to terminate the L2 classification rules configuration
mode:
npu(config-clsfrule-L2)# exit
3.4.12.11.4.13Displaying Configuration Information for Classification Rules
To display all or specific classification rules, run the following command:
npu# show clsf-rule [<rulename>]
Specify the classification rule name if you want to display configuration
information for a particular rule. Do not specify a value for this parameter if you
want to view configuration information for all classification rules.
Command
Syntax
npu(config-clsfrule-L2)# no cvid
Privilege
Level
10
Command
Modes
L2 Classification rules configuration mode
Command
Syntax
npu(config-clsfrule
-L2)# exit
Command
Modes
L2 Classification rules configuration mode