User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 260 System Manual
npu(config-srvcif-QinQ)# config ([descr <string>] [vlan-id <size(1-4094>])
3.4.12.8.3 Restoring the Default Configuration Parameters for an IP-IP Service
Interface
Run the following command to restore the default configuration for IP-IP service
interface chksm parameter:
npu(config-srvcif-ipip)# no tunnel [chksm]
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer to the syntax
description for more information about the appropriate values and format for configuring these
parameters.
At least one parameter must be specified (the value is optional): The command
npu(config-srvcif-QinQ)# config will return an Incomplete Command error.
Command
Syntax
npu(config-srvcif-QinQ)# config ([descr <string>] [vlan-id <size(1-4094>]])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
descr <string> A description of the service
interface.
Optional null String (up to 70
characters)
vlan-id
<size(1-4094>]
A Service Interface VLAN ID
shall not conflict with other
instances of Service Interface
VLAN ID and VLAN IDs of
Bearer, Local-Management
and External-Management
interfaces. Shall also not
conflict with CVID of any
transparent MS.
Note that the default (0) is not
a valid value.
Optional 0 1-9, 11-4094
Command
Modes
QinQ Service Interface configuration mode