User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 356 System Manual
3.4.12.11.4.8.3Disabling the Destination Port Range
You can run the following command to disable the destination port range that is
currently enabled:
npu(config-clsfrule-dstport)# no port-enable
3.4.12.11.4.8.4Terminating the Destination Port Configuration Mode
Run the following command to terminate the destination port configuration mode:
IMPORTANT
If destination port range is enabled, then:
IP protocol (protocol-enable) must be set to enabled.
Protocol can be either 6 (TCP) or 17 (UDP).
For details on these parameters refer to Section 3.4.12.11.4.4.2.
Command
Syntax
npu(config-clsfrule-dstport)# port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination port configuration mode
IMPORTANT
To enable this destination port range, run the following command:
npu(config-clsfrule-dstport)# port-enable
For details, refer to
“Enabling the Destination Port Range” on page 355.
Command
Syntax
npu(config-clsfrule-srcport)# no port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination port configuration mode