User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 355 System Manual
3.4.12.11.4.8.2Enabling the Destination Port Range
You can run the following command to enable the destination port range:
npu(config-clsfrule-dstport)# port-enable
You can also run this command to enable a destination port range that is
currently disabled. For details, refer to “Disabling the Destination Port Range” on
page 356.
IMPORTANT
An error may occur if you provide an invalid value for the start-port and end-port parameters.
Refer the syntax description for more information about the appropriate values and format for
configuring these parameters.
Command
Syntax
npu(config-clsfrule)# dstport <start-port> <end-port>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<start-port> Denotes the starting value of
port range to be configured.
Cannot be higher than
end-port.
Mandatory N/A 1-65535
<end-port> Denotes the end value of port
range to be configured.
Cannot be lower than
start-port.
Mandatory N/A 1-65535
Command
Modes
L3 Classification rules configuration mode