User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 353 System Manual
npu(config-clsfrule-srcport)# exit
3.4.12.11.4.7.5Deleting Source Ports Range
Run the following command to delete a source ports range classifier:
npu(config-clsfrule)# no srcport [<start-port> <end-port>]
Command
Syntax
npu(config-clsfrule-srcport)# exit
Privilege
Level
10
Command
Modes
L3 Classification rule-source port configuration mode
IMPORTANT
An error may occur if you provide an invalid value for the start-port and end-port parameters.
Refer the syntax description for more information about the appropriate values and format for
configuring these parameters.
Command
Syntax
npu(config-clsfrule)# no srcport [<start-port> <end-port>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<start-port> Denotes the starting value of
port range to be deleted.
Optional N/A 1-65535
<end-port> Denotes the end value of port
range to be deleted.
Optional N/A 1-65535
Command
Modes
L3 Classification rules configuration mode