User Manual
Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 352 System Manual
3.4.12.11.4.7.3Disabling the Source Port Range
Run the following command to disable the source port range that is currently
enabled:
npu(config-clsfrule-srcport)# no port-enable
3.4.12.11.4.7.4Terminating the Source Port Configuration Mode
Run the following command to terminate the source port configuration mode:
IMPORTANT
If source port range is enabled, then:
IP protocol (protocol-enable) must be set to enabled.
Protocol can be either 6 (TCP) or 17 (UDP).
For details on these parameters refer to Section 3.4.12.11.4.4.2.
Command
Syntax
npu(config-clsfrule-srcport)# port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-source port configuration mode
IMPORTANT
To enable this source port range, run the following command:
npu(config-clsfrule-srcport)# port-enable
For details, refer to
“Enabling the Source Port Range” on page 351.
Command
Syntax
npu(config-clsfrule-srcport)# no port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-source port configuration mode