User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 351 System Manual
The configuration mode for the newly created source port is automatically
enabled, after which you can enable/disable the source port range (refer to
Section 3.4.12.11.4.7.2/Section 3.4.12.11.4.7.3).
You can then terminate the source port configuration mode (refer to
Section 3.4.12.11.4.7.4) and return to the classification rules configuration mode.
3.4.12.11.4.7.2Enabling the Source Port Range
Run the following command to enable the source port range:
npu(config-clsfrule-srcport)# port-enable
You can also run this command to enable a source port range that is currently
disabled. For details, refer to “Disabling the Source Port Range” on page 352.
Command
Syntax
npu(config-clsfrule)# srcport <start-port> <end-port>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<start-port> Denotes the starting value of
port range to be configured.
Cannot be higher than
end-port.
Mandatory N/A 1-65535
<end-port> Denotes the end value of port
range to be configured.
Cannot be lower than
start-port.
Mandatory N/A 1-65535
Command
Modes
L3 Classification rules configuration mode