User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 349 System Manual
3.4.12.11.4.6.4Terminating the Destination Address Configuration Mode
Run the following command to terminate the destination address configuration
mode:
npu(config-clsfrule-dstaddr)# exit
3.4.12.11.4.6.5Deleting Destination Address
You can, at any time, run the following command to delete the destination
address classifier:
npu(config-clsfrule)# no dstaddr [<ip-Addr>]
Command
Syntax
npu(config-clsfrule-dstaddr)# exit
Privilege
Level
10
Command
Modes
L3 Classification rule-destination address configuration mode
IMPORTANT
An error may occur if you provide an invalid IP address. Refer the syntax description for more
information about the appropriate values and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# no dstaddr [<ip-Addr>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<ip-Addr>] Denotes the IPv4 address of
the destination address that
you want to delete from a
classification rule.
Optional N/A Valid IP
Address