User Manual

Chapter 3 - Operation and Administration of the Macro BTS NPU Configuration
4Motion 259 System Manual
3.4.12.8.2.3 Configuring Parameter for QinQ Service Interface
After enabling the QinQ Service Interface configuration mode, run the following
command to configure the QinQ service interface parameters:
This command shall configure one or more parameters of the QinQ Service
Interface.
[dflt-gw-ip <ip
address> <mask>]
The IP Address and subnet
mask of the Default Gateway.
The IP address shall be
unique among all the Host
Interfaces IP's (Bearer,
Local-Management,
Internal-Management,
External-Management) and
existing instances of Service
Interface’s Tunnel Destination
IP Address and Default
Gateway IP Address.
Interface mask should be
configured in such a way that
the resulting subnet should
not overlap with an existing
Interface subnet (host
interfaces, other service
interfaces).
Should be in the same
subnet.with the IP Address of
the DHCP server/proxy/relay
to be assigned to a service
group using this service
interface.
Must be changed from the
default value. The Default
Gateway IP Address of an
existing service interface
cannot be changed. The
Subnet Mask of a service
interface associated to a
service group cannot be
changed.
Optional 0.0.0.0
255.255.
255.0
valid IP
address and
mask
Command
Modes
VLAN Service Interface configuration mode