User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 644 System Manual
3.9.26.3 Restoring the Default Value of the Beam Forming Parameter
To restore the default values of the Beam Forming parameters, run the following
command:
npu(config-bs-66053)# no beamform [cal-atten ]
3.9.26.4 Displaying Configuration Information for Beam Forming
Parameter
To display configuration information of the Beam Forming parameters, run the
following command:
npu# show beamform bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Beam Forming parameter of BS 66053, run the following
command:
npu# show beamform bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show beamform bs
Command
Syntax
npu(config-bs-66053)# no beamform [cal-atten ]
Privilege
Level
10
Command
Modes
bs beamform configuration mode
Command
Syntax
npu# show beamform bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1