User Manual
Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 643 System Manual
After enabling the Beam Forming configuration mode, you can execute the
following tasks:
Configure the Beam Forming parameter (refer to Section 3.9.26.2).
Restore the default values of the Beam Forming parameter (refer to
Section 3.9.26.3).
You can display configuration value for the beamforming parameter of a selected
or all existing BSs (refer to Section 3.9.26.4).
3.9.26.2 Configuring the Beam Forming Parameter
From the beamforming configuration mode, run the following command:
npu(config-bs-66053-beamform)# beamform [cal-atten {noAttenUsed |
lowAtten | highAtten} ]
To configure the Beam Forming parameter:
Command
Syntax
npu(config-bs-66053)# beamform [cal-atten {noAttenUsed | lowAtten |
highAtten} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
cal-atten
{noAttenUsed |
lowAtten |
highAtten
Applicable only in Beam
Forming DL Diversity
Mode. The calibration
attenuation used to help
mitigate potential out of
band interference to beam
forming calibration caused
by other base stations.
Optional lowAtten
noAttenUs
ed
lowAtten
highAtten
Command
Modes
bs beamform configuration mode