User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 642 System Manual
npu# show ASNGWLoadBalancing bs [<(1 to 16777215 StepSize 1)> ]
Specify the BS ID if you want to display information for a particular BS. For
example, to display the ASN-GW Load Balancing configuration parameters of BS
66053, run the following command:
npu# show ASNGWLoadBalancing bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show ASNGWLoadBalancing bs
3.9.26 Managing Beam Forming Parameter
The Beam Forming Calibration Attenuator parameter is applicable only if the
Downlink Diversity Mode parameter is set to Beam Forming (see “Configuring the
Airframe Downlink Diversity Mode Parameter” on page 568).
3.9.26.1 Enabling the Beam Forming Configuration Mode
From the BS configuration mode, run the following command:
npu(config-bs-66053)# beamform
Command
Syntax
ASNGWLoadBalancing bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
1
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB : <value>
ASN-GWPoolPrimary : <enable(1)/disable(2)>
ASN-GWPoolSecondary : <enable(1)/disable(2)>
Command
Modes
Global command mode
To enable the Beam Forming Configuration Mode: