User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 640 System Manual
3.9.25.2 Enabling/Disabling an ASN-GW Load Balancing Pool
After enabling the ASN-GW Load Balancing configuration mode, run the following
command to enable/disable ASN-GW load balancing pools:
npu(config-bs-5-ASNGWLoadBalancing)# asNGWLoadBalancing [asn-gw-pool-1
{enable | disable} ] [asn-gw-pool-2 {enable| disable} ]
Note: After enabling Pool 1 and/or Pool 2, the AU must be reset to apply the
change.
Command
Syntax
npu(config-bs-66053)# asNGWLoadBalancing
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
nnpu(config-bs-5-ASNGWLoadBalancing)# asNGWLoadBalancing [asn-gw-pool-1 {enable |
disable} ] [asn-gw-pool-2 {enable| disable} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[asn-gw-pool-1 {enable |
disable} ]
Enable/disable the
use of pool 1
Optional Enable
 Enable
 Disable
[asn-gw-pool-2 {enable |
disable} ]
Enable/disable the
use of pool 2.
Pool 2 cannot be
enabled if Pool 1 is
disabled.
Optional Enable
 Enable
 Disable
Command
Modes
bs asn-gw load balancing configuration mode