User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 637 System Manual
3.9.24.2 Restoring the Default Values of Scheduler Parameters
To restore the default values of some or all of the Scheduler parameters, run the
following command:
npu(config-bs-66053)# no scheduler [scheduler-mode ]
[dl-abuse-protection-level ] [ul-abuse-protection-level ]
You can restore only some parameters to the default values by specifying only
those parameter. For example, to restore only the ul-abuse-protection-level
parameter to the default value, run the following command:
npu(config-bs-66053)# no scheduler ul-abuse-protection-level
This parameter will be restored to its default value, while the other parameters
will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-bs-66053)# no scheduler
To apply the changes, run the following command:
npu(config-bs-66053)# scheduler-apply
3.9.24.3 Displaying Configuration Information for Scheduler
Parameters
To display configuration information of Scheduler parameters, run the following
command:
npu# show scheduler bs [<(1 to 16777215 StepSize 1)
NOTE
Refer to Section 3.9.24.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no scheduler [scheduler-mode ] [dl-abuse-protection-level ]
[ul-abuse-protection-level ]
Privilege
Level
10
Command
Modes
bs configuration mode