User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 556 System Manual
3.9.10 Managing the RF Frequency Parameter
After enabling the BS configuration mode, you can configure the RF frequency
parameter (refer to Section 3.9.10.1).
You can display configuration information for the RF frequency parameter of a
selected or all existing BSs (refer to Section 3.9.10.2).
3.9.10.1 Configuring the RF Frequency Parameter
From the BS configuration mode, run the following command:
npu(config-bs-66053)# rf [frequency <(2022.5 to 2217.5 StepSize 0.125) |
(2302.5 to 2397.5 StepSize 0.125) | (2487.5 to 2687.5 StepSize 0.125) | (3302.5
to 3397.5 StepSize 0.125) | (3402.5 to 3597.5 StepSize 0.125) | (3602.5 to 3797.5
StepSize 0.125)>]
Command
Modes
Global command mode
To configure the RF frequency parameter:
Command
Syntax
npu(config-bs-66053)# rf [frequency <((2022.5 to 2217.5 StepSize
0.125) | (2302.5 to 2397.5 StepSize 0.125) | (2487.5 to 2687.5
StepSize 0.125) | (3302.5 to 3397.5 StepSize 0.125) | (3402.5 to
3597.5 StepSize 0.125) | (3602.5 to 3797.5 StepSize 0.125)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values