User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 633 System Manual
3.9.23.2 Displaying Configuration Information for the BS Idle Mode
Parameter
To display configuration information of the BS Idle Mode parameter of a specific or
all BSs, run the following command:
npu# show idle-mode bs [<(1 to 16777215 StepSize 1)>]
Specify the BS ID (1-16777215) of an existing BS if you want to display
configuration information for a particular BS. Do not specify values for this
parameter if you want to view configuration information for all existing BSs.
Command
Syntax
npu(config-bs-66053)# idle-mode [paging-group-id <(0 to 65535
StepSize 1)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[paging-group-id <(0 to
65535 StepSize 1)> ]
The Paging Group ID
of the BS.
0 means that Idle
Mode is disabled.
If other than 0
(disable), should be
unique in the network
(different
paging-group for each
BS).
Mandatory 0 0 to 65535
Command
Modes
bs configuration mode
Command
Syntax
npu# show idle-mode bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
1