User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 624 System Manual
You can display configuration and status information for the Alarm Threshold
parameters of a selected or all existing BSs (refer to Section 3.9.20.3).
3.9.20.1 Configuring Alarm Threshold Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# alrm-thrshld [ul-mednoise <(-135 to -100 StepSize 1)>]
[ul-99prcntnoise <(-135 to -100 StepSize 1)>] [Be-exc-dl-drop-thr <(1 to 1000
StepSize 1)> ] [rt-exc-dl-drop-thr <(1 to 1000 StepSize 1)> ] [nrt-exc-dl-drop-thr
<(1 to 1000 StepSize 1)> ] [ugs-exc-dl-drop-thr <(1 to 1000 StepSize 1)> ]
[ert-exc-dl-drop-thr <(1 to 1000 StepSize 1)> ]
To configure the Alarm Threshold parameters:
Command
Syntax
npu(config-bs-66053)# alrm-thrshld [ul-mednoise <(-135 to -100
StepSize 1)> ] [ul-99prcntnoise <(-135 to -100 StepSize 1)> ]
[Be-exc-dl-drop-thr <(1 to 1000 StepSize 1)> ] [rt-exc-dl-drop-thr
<(1 to 1000 StepSize 1)> ] [nrt-exc-dl-drop-thr <(1 to 1000
StepSize 1)> ] [ugs-exc-dl-drop-thr <(1 to 1000 StepSize 1)> ]
[ert-exc-dl-drop-thr <(1 to 1000 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values