User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs

4Motion 599 System Manual

3.9.16.1 Enabling the Bearer Traffic QoS Marking Rule Configuration

Mode\Creating a Bearer Traffic QoS Marking Rule

To configure the parameters of a Bearer Traffic QoS Marking Rule, first enable the

BS Bearer Traffic QoS Marking Rule configuration mode for the specific Bearer

Traffic QoS Marking Rule. Run the following command to enable the BS Bearer

Traffic QoS Marking Rule configuration mode. You can also use this command to

create a new Bearer Traffic QoS Marking Rule.

Note that for a new Bearer Traffic QoS Marking Rule this command only defines

the Bearer Traffic QoS Marking Rule number, and that the Bearer Traffic QoS

Marking Rule is not fully created until completing configuration of all mandatory

parameters and executing the apply command (must be executed before exiting

the Bearer Traffic QoS Marking Rule configuration mode). Also when updating an

existing Bearer Traffic QoS Marking Rule, the apply command must be executed

prior to termination the Bearer Traffic QoS Marking Rule configuration mode.

npu(config-bs-66053)# bearertrafficqos <(1 to 16383 StepSize 1)>

For example, to define a new Bearer Traffic QoS Marking Rule number 1, or to

enable the configuration mode for Bearer Traffic QoS Marking Rule 1, run the

following command:

npu(config-bs-66053)# bearertrafficqos 1

If you use this command to create a new Bearer Traffic QoS Marking Rule, the

configuration mode for this Bearer Traffic QoS Marking Rule is automatically

enabled, after which you can execute any of the following tasks:

 Configure one or more of the parameters of the Bearer Traffic QoS Marking

Rule (refer to Section 3.9.16.2)

 Restore the default values of Bearer Traffic QoS Marking Rule non-mandatory

parameters (refer to Section 3.9.16.3)

After executing the above tasks, you can terminate the Bearer Traffic QoS Marking

Rule configuration mode (refer to Section 3.9.16.4) and return to the BS

configuration mode.

Command

Syntax

npu(config-bs-66053)# bearertrafficqos <(1 to 16383 StepSize 1)>

Privilege

Level