User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 596 System Manual
3.9.15 Displaying Status Information for Handover
Control Parameters
After enabling the BS configuration mode, you can display information for the
Handover Control parameters of a selected or all existing BSs (refer to
Section 3.9.16).
To display configuration and status information of Handover Control parameters,
run the following command:
npu# show hoctrl bs [<(1 to 16777215 StepSize 1)
Command
Syntax
npu# show auth-general bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display Authentication
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display Authentication
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
Command
Modes
Global command mode