User Manual
Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 595 System Manual
maxeaproundsthrshld parameters to the default values, run the following
command:
npu(config-bs-66053)# no auth-general activemsthrshld
maxeaproundsthrshld
These parameters will be restored to their default values, while the other
parameters will remain unchanged.
To restore all Authentication parameters to their default value, run the following
command:
npu(config-bs-66053)# no auth-general
3.9.14.3 Displaying Configuration Information for Authentication
Parameters
To display configuration information of Authentication parameters, run the
following command:
npu# show auth-general bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Authentication parameters of BS 66053, run the following
command:
npu# show auth-general bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show auth-general bs
NOTE
Refer to Section 3.9.14.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no auth-general [suspendedeapprocthrshld ] [activemsthrshld ]
[maxeaproundsthrshld ]
Privilege
Level
10
Command
Modes
bs configuration mode