User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 592 System Manual
In addition to the configurable parameters, the ASNGW Status parameter is also
displayed. This is the Bearer Interface connectivity status (up/down/unknown). If
keep alive is disabled the connectivity status will be unknown. Note that the
keep-alive mechanism will start only after first registration, and until then this
mechanism is disabled and connectivity status is unknown.
3.9.14 Managing Authentication Relay Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Authentication parameters (refer to
Section 3.9.14.1).
 Restore the default values of some or all of the Authentication non-mandatory
parameters (refer to Section 3.9.14.2).
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display Bearer Interface
parameters of a specific BS.
Do not specify a value for this
parameter if you want to
display Bearer Interface
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
IPAddress :<value>
IPsubnetMask :<value>
DefaultGateway :<value>
BearerVLANID :<value>
ASNGWStatus :<value>
Command
Modes
Global command mode