User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 590 System Manual
3.9.13.2 Restoring the Default Values of Bearer Interface Parametes
To restore the default values of the Bearer Interface bearer-vlan parameter, run
the following command:
npu(config-bs-66053)# no bearer [bearer-vlan]
[ip-address <ip address>
]
The IP address of the
bearer interface of the
BS. Must be unique in
the network. All BS
bearer interfaces of the
unit should be in the
same subnet, together
with the NPU’s bearer
interface (if applicable).
Mandatory
when creating a
new BS.
N/A IP address
[ip-subnetmask <ip
address> ]
The IP subnet mask of
the bearer interface of
the BS
Mandatory
when creating a
new BS.
N/A Subnet mask
[dflt-gw <ip address> ] The IP address of the
default gateway of the
bearer interface of the
BS. Must be in the
same subnet with the
BS bearer ip interface.
Mandatory
when creating a
new BS.
N/A IP address
[bearer-vlan <(9 to 9
StepSize 1) | (11 to 100
StepSize 1) |(110 to 4094
StepSize 1)> ]
The VLAN ID of the
bearer interface of the
BS.
Must be equal to the
VLAN ID of the Bearer
interface (see
Section 3.4.2.3.5)
Optional 11 9, 11-100,
110-4094.
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, the Bearer Interface mandatory parameters must be configured.
NOTE
Refer to Section 3.9.13.1 for a description and default value of this parameter.