User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 589 System Manual
3.9.13 Managing BS Bearer Interface Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the Bearer Interface parameters (refer to
Section 3.9.13.1).
 Restore the default values of some or all of the Bearer Interface parameters
(refer to Section 3.9.13.2).
You can display configuration information for the Bearer Interface parameters of a
selected or all existing BSs (refer to Section 3.9.13.3).
3.9.13.1 Configuring Bearer Interface Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# bearer [ip-address <ip address>] [ip-subnetmask <ip
address>] [dflt-gw <ip address>] [bearer-vlan <(9 to 9 StepSize 1) | (11 to 100
StepSize 1) |(110 to 4094 StepSize 1)> ]
To configure the Bearer Interface Parameters:
Command
Syntax
npu(config-bs-66053)# bearer [ip-address <ip address> ]
[ip-subnetmask <ip address> ] [dflt-gw <ip address> ] [bearer-vlan
<(9 to 9 StepSize 1) | (11 to 100 StepSize 1) |(110 to 4094
StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Defaul
t Value
Possible
Values