User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 578 System Manual
npu(config-bs-66053-airframe)# no mimo
3.9.12.4 Terminating the Airframe Configuration Mode
Run the following command to terminate the Airframe configuration mode:
npu(config-bs-66053-airframe)# exit
3.9.12.5 Displaying Configuration Information for Airframe
Parameters
You can display the current configuration information for the following Airframe
parameters tables:
 General (refer to Section 3.9.12.5.1)
NOTE
Refer to Section 3.9.12.2.7 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no mimo [first-zone-min-size ]
[first-zone-max-size ] [max-map-size ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the Airframe configuration mode:
npu(config-bs-66053-airframe)# apply
Command
Syntax
npu(config-bs-66053-airframe)# exit
Privilege
Level
10
Command
Modes
bs airframe configuration mode