User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 577 System Manual
3.9.12.3.3 Restoring the Default Value of Airframe Downlink Diversity Mode
Parameter
To restore the Airframe Downlink Diversity mode parameter to its default value,
run the following command:
npu(config-bs-66053-airframe)# no dldiversity mode
Since the Downlink Diversity table contains a single parameter, it is sufficient to
run the following command:
npu(config-bs-66053-airframe)# no dldiversity
3.9.12.3.4 Restoring the Default Values of Airframe MIMO Parameters
To restore one or all of the Airframe MIMO parameters to their default values, run
the following command:
npu(config-bs-66053-airframe)# no mimo [first-zone-min-size ]
[first-zone-max-size ] [max-map-size ]
To restore all MIMO parameters to their default values, run the following
command:
Privilege
Level
10
Command
Modes
bs airframe configuration mode
NOTE
Refer to Section 3.9.12.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no dldiversity [mode ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode