User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 573 System Manual
Recommended values for First Zone Minimum Size and Maximum Size:
[first-zone-mi
n-size <(-1 to
-1 StepSize 1)
| (2 to 34
StepSize 2)> ]
Determines the initial size
(in OFDMA symbols) of the
first zone. When reuse 3 is
used within first zone, this
parameter should be equal
across all BSs within
deployment.
See recommended values
in Table
3-31 below. Other
values should be avoided.
In the current release this is
the actual size of the first
zone.
For reuse 1 the default (no
limitation) can be used-the
actual size will be set
dynamically according to
the configuration. For reuse
3 a specific value must be
configured.
Optional -1 (no
limitation)
-1 (no
limitation) or
2xN where N=1
to 17.
[first-zone-ma
x-size <(-1 to
-1 StepSize 1)
| (2 to 34
StepSize 2)> ]
Maximum size (in OFDMA
symbols) for first zone.
Used mainly for
performance control
capability within frame.
Cannot be lower than
first-zone-min-size.
In the current release the
value of this parameter is
ignored First Zone size is
defined only by
first-zone-min-size.
Optional -1 (no
limitation)
-1 (no
limitation) or
2xN where N=1
to 17.
[max-map-size <(-1
to -1 StepSize 1) |
(10 to 300 StepSize
10)> ]
Limits the maximum size of
maps (in slots)
Optional -1 (no
limitation)
-1 (no
limitation) or 10
to 300 in steps
of 10.
Command
Modes
bs airframe configuration mode