User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 569 System Manual
3.9.12.2.4 Configuring Airframe Uplink Feedback Zone Parameter
To configure the Airframe Uplink Feedback Zone parameter, run the following
command:
npu(config-bs-66053-airframe)# ulfeedbackzone permbase <(0 to 69 StepSize
1)>
Command
Syntax
npu(config-bs-66053-airframe)# dldiveraity [mode <matrixAorB |
beamForming>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
mode
<matrixAorB
|beamForming>
The diversity mode used in
downlink transmissions.
beamForming is not
applicable for 2-channels
AU.
Optional matrixA0rB
 matrixAorB
 beamForming
Command
Modes
bs airframe configuration mode
IMPORTANT
When creating a new BS, the Airframe Structure Uplink Feedback Zone mandatory permbase
parameter must be configured.
Command
Syntax
npu(config-bs-66053-airframe)# ulfeedbackzone permbase <(0 to 69
StepSize 1)>
Privilege
Level
10