User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 567 System Manual
majorgrps
<hex-string>
The Major groups allocated
to the BS for maps
transmission.
Two hexadecimal numbers
representing 8 bits
numbered 0 to 7 (left to
right). Bits 0 to 5 indicate
whether Subchannel
Groups 0 to 5 (respectively)
are allocated. Bit 6 and 7
are set to 0.
If BW=5 MHz, bits 1, 3 and
5 are not relevant ("don't
care"). The value must be
set to A8.
For BW=7/10 MHz with
Reuse 1, bits 0 to 5 must be
set. The value must be set
to fc.
For BW=7/10 MHz with
Reuse 3: If segment (see
Section 3.9.12.2.1) = 0,
then bits #0 and 1 should
be set. The value must be
set to c0.
If segment = 1, then bits #2
and 3 should be set. The
value must be set to 30.
If segment = 2, then bits #4
and 5 should be set. The
value must be set to 0c.
Mandatory
when
creating a
new BS.
N/A a string of two
hexadecimal
numbers.
repetition <(1 to 1
StepSize 1) | (2 to 6
StepSize 2)>
The basic repetition used in
the transmission of the
maps using QPSK 1/2 (1
means no repetitions).
Optional 6 1, 2, 4, 6
RCID-Usage
{enable | disable}
Indicates whether RCID
should be used,
Optional disable
 enable
 disable
Command
Modes
bs airframe configuration mode