User Manual

Chapter 4 - Operation and Administration of the Micro BTS GPS Menu
4Motion 742 System Manual
4.9.1.11 Advance Hour Factor
When Daylight Saving is enabled, this parameter defines the amount of time by
which the clock should be advanced during the daylight saving period.
The available values are 0 (daylight saving disabled), 1 and 2 (hours). The default
is 0.
4.9.1.12 Start Date
When Daylight Saving is enabled, this parameter defines the date for starting the
daylight saving feature. At the beginning of this date (midnight at the beginning of
this date), the clock will be advanced by the amount of hours specified by the
Advance Hour Factor.
Use the format dd.mm to define the date and month at which to start activating
the Daylight Saving feature.
4.9.1.13 Stop Date
When Daylight Saving is enabled, this parameter defines the date for ending the
daylight saving feature (at “Advance Hour Factor” hours after midnight at the end
of this date).
Use the format dd.mm to define the date and month at which to end activating the
Daylight Saving feature.
4.9.2 Inventory & Statuses
The Inventory & Statuses menu enables viewing the following read-only properties
and status parameters:
4.9.2.1 Navigation Processor SW Version
The software version of the navigation processor of the GPS receiver (if used).
4.9.2.2 Signal Processor SW Version
The software version of the signal processor of the GPS receiver (if used).
4.9.2.3 Number of Satellites
The number of satellites currently acquired by the GPS.
4.9.2.4 1PPS Failure
The status of External 1PPS clock (OK or Failed).