User Manual

Chapter 4 - Operation and Administration of the Micro BTS Equipment Menu
4Motion 738 System Manual
4.8.2.1.8 Required Port Configuration
Read-only. The port configuration according to the properties defined by the
installed radio type.
4.8.2.1.9 Serial Number
Read-only. The serial number of the radio card.
4.8.2.2 Port
The Radio Port menu enables viewing the general radio port properties and status
and viewing/updating some general parameters.
4.8.2.2.1 TX Power
The required Tx power at the radio port, in dBm.
The actually available range depends on Radio Type: The upper limit, which is the
default, is set by the Maximum Tx Power supported by the radio. The control
range is 10 dBm.
4.8.2.2.2 HW Revision
Read-only. The HW revision of the radio port card.
4.8.2.2.3 HPA Card
Read-only. An indication whether an HPA (High Power Amplifier) card in installed.
4.8.2.2.4 HPA HW Version
Read-only. Applicable only if HPA card is installed. The HW version of the HPA
card.
4.8.2.2.5 Serial Number
Read-only. The serial number of the radio port card.
4.8.2.2.6 RSSI
Read-only. Average uplink RSSI in dBm of all bursts of all connected MSs.
4.8.3 Antenna
Typically a 2-ports dual slant antenna is used. In cases where 2 separate
antennas are used, the Antenna parameters are applicable for both antennas.
The Antenna menu enables viewing/updating the following parameters:
4.8.3.1 Antenna Type
An optional descriptive text. Up to 254 characters.