User Manual

Chapter 4 - Operation and Administration of the Micro BTS BS Menu
4Motion 730 System Manual
 “Primary Pool”
 “Secondary Pool”
4.7.2.7.4.1 Pools Availability
The Pools Availability option enables viewing/updating the status
(Enabled/Disabled) of each of the pools. The Secondary Pool can be enabled only
if the Primary Pool is enabled.
4.7.2.7.4.2 Primary Pool
The Primary Pool option enables viewing the IP Address and current Connectivity
Status for each of the ASN-GWs in the pool, based on selection of the ASN-GW
Index.
4.7.2.7.4.3 Secondary Pool
The Secondary Pool option enables viewing the IP Address and current
Connectivity Status for each of the ASN-GWs in the pool, based on selection of the
ASN-GW Index.
4.7.2.8 Management
The Management menu includes the following options:
 “Noise and Interference Level Thresholds”
 “DL Dropped Packets Ratio Thresholds”
4.7.2.8.1 Noise and Interference Level Thresholds
The Noise and Interference Level Thresholds menu enables viewing/updating the
values configured for the following parameter:
4.7.2.8.1.1 Uplink Median Noise
The uplink median noise level represents the median value of the noise floor
histogram. If the uplink median noise level exceeds this value, an excessive uplink
median noise alarm will be generated.
The value is in dBm/tone. The default value of -124 is set to 3 dB above the
default value of the Target NI parameter.
The range is from -135 to -100 (dBm)
4.7.2.8.2 DL Dropped Packets Ratio Thresholds
The DL Dropped Packets Ratio Thresholds menu enables viewing/updating the
values configured for the following parameters: