User Manual

Chapter 4 - Operation and Administration of the Micro BTS BS Menu
4Motion 727 System Manual
4.7.2.7.2.2 Thresholds - Suspended EAP Process
Suspended EAP authentication process threshold. It is used to set an alarm.
The range is 0-10000. The default is 10000.
Note: The relevant alarm is not supported in current release.
4.7.2.7.2.3 Threshold - Active MSs
The threshold for the number of MSs in active operation state (not Idle) served by
the BS. Exceeding this threshold sets the alarm “Excessive MS number”.
The range is 0-1024. When set to 0, the alarm is disabled. The default is 1024.
4.7.2.7.2.4 Threshold - Maximum EAP Rounds
The threshold for the number of EAP rounds in one direction in the same EAP
session. When this threshold is exceeded, alarm is set. This threshold may be
used to protect the system from hazard EAP sessions with extreme number of
messaging round trips.
The range is 0-100. When set to 0, the alarm is disabled. The default is 100.
Note: The relevant alarm is not supported in current release.
4.7.2.7.3 QOS Marking Rules
The QoS Marking Rules menu includes the following options:
 “Internal ASN Traffic QOS Rules”
 “Internal Management Traffic QOS Rules”
 “QOS Rules”
4.7.2.7.3.1 Internal ASN Traffic QOS Rules
The Internal ASN Traffic QOS Rules menu enables viewing/updating the values
configured for the following parameters:
 “Diffserv Code Point”
 “802.1p Priority”
4.7.2.7.3.1.1Diffserv Code Point
DSCP priority value to be used for marking of intra-ASN (R8/R6) traffic. The range
is 0-63. The default is 0.