User Manual

Chapter 4 - Operation and Administration of the Micro BTS BS Menu
4Motion 717 System Manual
4.7.2.2.3.3 Minimum Size
The initial size (in symbols) of the first zone. When reuse 3 is used within first
zone, this parameter should be equal across all BSs within deployment.
The available options are 2, 4,....34 (2xN where N=1-17) or No Limitation. The
default is No Limitation.
See limitations in “First Zone Minimum Size Recommended Value Range” table
below. Other values should be avoided.
In the current release this is the actual first zone size. For reuse 1 the default (no
limitation) can be used-the actual size will be set dynamically according to the
configuration. For reuse 3 a specific value must be configured.
4.7.2.2.3.4 Maximum Size
Maximum size (in symbols) for first zone. Used mainly for performance control
capability within frame.
The available options are 2, 4,....34 (2xN where N=1-17) or No Limitation. The
default is No Limitation.
Maximum Size cannot be lower than Minimum Size.
In the current release this parameter is not applicable (first zone size is defined
only by the Minimum Size parameter).