User Manual

Chapter 4 - Operation and Administration of the Micro BTS BS Menu
4Motion 716 System Manual
4.7.2.2.3 First Zone
The First Zone menu enables viewing/updating the values configured for the
following parameters:
 “Major Group”
 “Basic Map Repetition”
 “Minimum Size”
 “Maximum Size”
 “Maximum Map Size”
4.7.2.2.3.1 Major Group
The major groups allocated to the BS for maps transmission. Two hexadecimal
digits in the range 00 to fc, representing 8 bits numbered 0 to 7 (left to right). Bits
0 to 5 indicate whether Subchannel Groups 0 to 5 (respectively) are allocated. Bits
6 and 7 are set to 0.
If BW=5 MHz, bits 1, 3 and 5 are not relevant ("don't care"). bits 0, 2, and 4 should
be set. Major Group must be set to A8.
If BW=7/10 MHz with reuse 1, bits 0 to 5 must be set. The value must be set to fc.
For BW=7/10 MHz with Reuse 3:
 If Segment Number = 0, then bits #0 and 1 should be set. The value must be
set to c0.
 If Segment Number = 1, then bits #2 and 3 should be set. The value must be
set to 30.
 If Segment Number = 2, then bits #4 and 5 should be set. The value must be
set to 0c.
4.7.2.2.3.2 Basic Map Repetition
The basic repetition used in the transmission of the maps using QPSK 1/2. The
available options are 1, 2, 4 and 6. (1 means no repetitions).
The default is 6 (rate QPSK 1/2 repetition 6)