User Manual

Chapter 4 - Operation and Administration of the Micro BTS BTS Menu
4Motion 696 System Manual
unique number in the range from 1 to 10) before defining the ASN-GW IP
address. An IP address must be unique per both pools.
 Select: Use this option to select an entry in the pool by it’s index. You can then
view the entry’s IP address, update the IP address, or delete the entry.
4.5.2.3 L1 & L2
The L1 & L2 option enables viewing or updating the parameters of the Ethernet
interface:
 Operational State: The read-only operational status of the port (Up or Down).
 Administrative State: The administrative status of the port (Up or Down).
 Auto Negotiation: The mode for negotiating the port speed and the duplex
mode with the link partner (Auto or Manual). The default is Auto.
 Port Speed: The port speed to be used for the physical interface (valid values
are 10, 100 or 1000 Mbps). Configurable only if Auto Negotiation is set to
Manual. The default is 1000 Mbps.
 Duplex Mode: The duplex mode for the interface (Full-Duplex or Half Duplex).
Configurable only if Auto Negotiation is set to Manual. The default is
Full-Duplex.
4.5.3 Unit Control
The Unit Control menu enables various general control functions such as
resetting the BTS, managing the SW versions of the BTS and
uploading/downloading configuration backup files.
The Unit Control menu includes the following options:
 “Reset”
 “Monitor Inactivity Timeout”
 “SW Version Control”
 “TFTP Server”
 “Files Control”