User Manual

Chapter 3 - Operation and Administration of the Macro BTS Troubleshooting
4Motion 674 System Manual
3.12.1.2 Configuring Module-level Tracing
After configuring module-level tracing, you can specify whether brief or detailed
traces should be recorded for the following modules:
System startup procedures
NPU/AU upgrade procedures
Fault management procedures
System performance procedures
Shelf Management procedures
WiMAX signaling protocols
User interface
AU Management procedures
IMPORTANT
This command may not be successfully executed if an internal error occurs while processing the
result.
Command
Syntax
npu(config)# show trace destination
Privilege
Level
1
Display
Format
Trace File : <Enabled/Disabled>
Console : <Enabled/Disabled>
Trace Server : <Enabled/Disabled>
(ServerIP - <IP address>)
Command
Modes
Global command mode