User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 559 System Manual
3.9.11.1 Configuring the Baseband Bandwidth Parameter
From the BS configuration mode, run the following command:
npu(config-bs-66053)# baseband [bandwidth {fiveMHz | tenMHz | sevenMHz}]
Note that the valid value ranges (and in some cases also default value) of certain
parameters are affected by the value configured for the bandwidth parameter. If
you change the bandwidth, verify that these parameters are configured properly:
To configure the Baseband bandwidth parameter:
IMPORTANT
A bandwidth of 7 MHz (sevenMHz) is not applicable for ODUs in the 2.x GHz band.
Command
Syntax
npu(config-bs-66053)# baseband [bandwidth {fiveMHz | tenMHz |
sevenMHz} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[bandwidth {fiveMHz |
tenMHz | sevenMHz} ]
BS channel
bandwidth
Mandatory N/A
 fiveMHz
 tenMHz
 sevenMHz
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, the mandatory frequency parameter must be configured.
Table Parameters
RF (see Section 3.9.10.1) frequency