User Manual

Chapter 3 - Operation and Administration of the Macro BTS Managing BSs
4Motion 558 System Manual
3.9.11 Managing the Baseband Bandwidth
Parameter
After enabling the BS configuration mode, you can configure the Baseband
bandwidth parameter (refer to Section 3.9.11.1).
You can display configuration information for the Baseband bandwidth parameter
of a selected or all existing BSs (refer to Section 3.9.11.2).
Command
Syntax
npu# show rf bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display the RF frequency
parameter of a specific BS.
Do not specify a value for this
parameter if you want to
display the RF frequency
parameter of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
Frequency :<value>
Command
Modes
Global command mode