User Manual
Table Of Contents
- 4Motion System Manual
- About This Manual
- Contents
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 4Motion Solution
- 1.3 The Base Transceiver Station
- 1.4 Element Management Systems
- 1.5 Specifications
- 1.5.1 Modem & Radio
- 1.5.2 Sensitivity (per channel)*
- 1.5.3 ODUs
- 1.5.4 Micro Outdoor BTS
- 1.5.5 AU - ODU Communication (Macro BTS)
- 1.5.6 Data Communication (Ethernet Interfaces)
- 1.5.7 Configuration and Management
- 1.5.8 Standards Compliance, General
- 1.5.9 Environmental
- 1.5.10 Mechanical and Electrical
- 1.5.11 Antennas
- Chapter 2 - Commissioning of the Macro BTS
- 2.1 Initial NPU Configuration
- 2.2 Completing the Site Configuration Using AlvariSTAR
- Chapter 3 - Operation and Administration of the Macro BTS
- 3.1 Using the Command Line Interface
- 3.1.1 Managing the Macro Outdoor BTS
- 3.1.2 Accessing the CLI
- 3.1.3 Command Modes
- 3.1.4 Interpreting the Command Syntax
- 3.1.5 Using the CLI
- 3.1.6 Managing Users and Privileges
- 3.1.7 Managing Secure Shell (SSH) Parameters
- 3.1.8 Managing the Session
- 3.2 Managing Software Upgrade
- 3.1 Using the Command Line Interface
Chapter 1 - System Description Specifications
4Motion 33 System Manual
maximum Tx power of 33 dBm and without support of beam forming
capability.
b If you use ODU-2485-2690-000-N-38-4x2-N-0: Configure
oDU24962602000N334by2EtsiBFN0 as the required type. This will create
a “virtual” ODU supporting the frequency range 2496-2602 MHz with a
maximum Tx power of 33 dBm and support of beam forming capability.
c If you use ODU-2485-2690-000-N-38-2x2-N-0: Configure
oDU24962602000N332by2EtsiBFN0 as the required type. This will create
a “virtual” ODU supporting the frequency range 2496-2602 MHz with a
maximum Tx power of 33 dBm and support of beam forming capability.