User Manual

Table Of Contents
Chapter 1 - System Description Specifications
4Motion 32 System Manual
1.5.3.2.3 2.5 GHz Band 4x2 ODUs
1.5.3.2.4 Compliance with ETSI Regulations
For compliance with ETSI regulations for the 2.5 GHz Band A such as limiting the
Tx power to a maximum of 33dBm, one of the following must be done:
1 Use a suitable external filter.
2 Configure the required ODU type as follows:
a If you use ODU-2496-2602-000-N-38-4x2-N-0: Configure
oDU24962602000N334by2EtsiNO as the required type. This will create a
“virtual” ODU supporting the frequency range 2496-2602 MHz with a
Table 1-10: 2.5 GHz Band 4x2 ODUs Specifications
Item Description
Frequency Band ODU-2496-2602-000N-38-4x2-N-0: 2496-2602 MHz (Band A)
ODU-2590-2690-000N-38-4x2-N-0: 2590-2690 MHz (Band B)
ODU-2485-2690-000N-38-4X2-N-0: 2485-2690 MHz
ODU-2560-2570-000N-37-4X2-N-0: 2560-2570 MHz
Ports Configuration 4x2 (4Rx, 2Tx)
Bandwidth Support Up to 20 MHz
Beam Forming Support ODU-2485-2690-000N-38-4X2-N-0
Maximum Tx Power) 38 dBm
For ODU-2560-2570-000N-37-4X2-N-0: 37 dBm.
Tx Power Control Range 10 dB, in 1 dB steps
Tx Power Accuracy +/- 1 dB
Maximum Input Power @
antenna port
-60 dBm before saturation, -8 dBm before damage
Noise Figure 4.5 dB typical, 5.5 dB maximum
Dimension 420 x 340 x 270 mm
Weight 17 Kg
Connectors ANT: 4 x N-Type jack, 50 Ohm, lightning protected
IF: 4 x TNC jack, 50 Ohm, lightning protected
Power Source -40.5 to -60 VDC over the IF cable
Power Consumption Transmit - 180W maximum
Receive - 50W maximum