User Manual
Table Of Contents
- 4Motion System Manual
- About This Manual
- Contents
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 4Motion Solution
- 1.3 The Base Transceiver Station
- 1.4 Element Management Systems
- 1.5 Specifications
- 1.5.1 Modem & Radio
- 1.5.2 Sensitivity (per channel)*
- 1.5.3 ODUs
- 1.5.4 Micro Outdoor BTS
- 1.5.5 AU - ODU Communication (Macro BTS)
- 1.5.6 Data Communication (Ethernet Interfaces)
- 1.5.7 Configuration and Management
- 1.5.8 Standards Compliance, General
- 1.5.9 Environmental
- 1.5.10 Mechanical and Electrical
- 1.5.11 Antennas
- Chapter 2 - Commissioning of the Macro BTS
- 2.1 Initial NPU Configuration
- 2.2 Completing the Site Configuration Using AlvariSTAR
- Chapter 3 - Operation and Administration of the Macro BTS
- 3.1 Using the Command Line Interface
- 3.1.1 Managing the Macro Outdoor BTS
- 3.1.2 Accessing the CLI
- 3.1.3 Command Modes
- 3.1.4 Interpreting the Command Syntax
- 3.1.5 Using the CLI
- 3.1.6 Managing Users and Privileges
- 3.1.7 Managing Secure Shell (SSH) Parameters
- 3.1.8 Managing the Session
- 3.2 Managing Software Upgrade
- 3.1 Using the Command Line Interface
Document History
4Motion xxx System Manual
Mapping of Macro Outdoor BTS AUs
to Slot #
Table 3-1
Corrected mapping February 2010
Managing Neighbor BSs
Appendix 3.9.9
Removed Trigger Setup parameters. February 2010
Managing Trigger Setup Parameters Removed February 2010
Displaying Configuration and Status
Information for ODU Ports
Section 3.7.2.6
Added new read-only parameters
odu-status-mask
RSSI
February 2010
Managing Service Interfaces
Section 3.4.12.8
removed mtu (changed to vendor parameter) February 2010
Configuring IP Interfaces
Section 3.4.2.3
removed mtu (changed to vendor parameter) February 2010
Managing the Hot-Lining Feature
Section 3.4.12.13
New feature. February 2010
Configuring BS Keep-Alive
Parameters
Section 3.9.22.1
Corrected Possible Values range of rtx-cnt,
Updated Default of rtx-time.
February 2010
configuring ASN-GW Keep-Alive
Parameters
Section 3.4.12.14.1
Updated range and default for rtx-cnt,
updated range for rtx-time.
February 2010
Configuring General Configuration
Parameters for the GPS
Section 3.4.16.2.2
Updated default value for HoldoverTimeout February 2010
Managing the Context Function
Section 3.4.12.4
Updated to reflect the ability to configure the
ms-capacity-threshold parameter.
February 2010
Managing the Data Path Function
Section 3.4.12.3
Updated to reflect the ability to configure the
throughput-threshold parameter.
February 2010
Configuring/Displaying the Daylight
Saving Parameters
Sections
3.4.16.2.4,
3.4.16.2.10
New feature February 2010
Creating a Sector Association Entry
Section 3.10.2.1
Updated configuration rules February 2010
Sector Connections Schemes
Appendix A
New section, replacing previous Antenna
Configurations section
February 2010
Topic Description Date Issued