User Manual
Table Of Contents
- 4Motion System Manual
- About This Manual
- Contents
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 4Motion Solution
- 1.3 The Base Transceiver Station
- 1.4 Element Management Systems
- 1.5 Specifications
- 1.5.1 Modem & Radio
- 1.5.2 Sensitivity (per channel)*
- 1.5.3 ODUs
- 1.5.4 Micro Outdoor BTS
- 1.5.5 AU - ODU Communication (Macro BTS)
- 1.5.6 Data Communication (Ethernet Interfaces)
- 1.5.7 Configuration and Management
- 1.5.8 Standards Compliance, General
- 1.5.9 Environmental
- 1.5.10 Mechanical and Electrical
- 1.5.11 Antennas
- Chapter 2 - Commissioning of the Macro BTS
- 2.1 Initial NPU Configuration
- 2.2 Completing the Site Configuration Using AlvariSTAR
- Chapter 3 - Operation and Administration of the Macro BTS
- 3.1 Using the Command Line Interface
- 3.1.1 Managing the Macro Outdoor BTS
- 3.1.2 Accessing the CLI
- 3.1.3 Command Modes
- 3.1.4 Interpreting the Command Syntax
- 3.1.5 Using the CLI
- 3.1.6 Managing Users and Privileges
- 3.1.7 Managing Secure Shell (SSH) Parameters
- 3.1.8 Managing the Session
- 3.2 Managing Software Upgrade
- 3.1 Using the Command Line Interface
Document History
4Motion xxviii System Manual
Airframe Dynamic Permutations
Parameters
Section 3.9.12
Removed (changed to vendor parameters) February 2010
Configuring Airframe General
Parameters
Section 3.9.12.2.1
Updated value range for ul-duration and
frame-offset. Added nbr-beam-forming.
February 2010
Configuring Airframe Map Zone
Parameters
Section 3.9.12.2.2
Added RCID-Usage February 2010
Configuring Airframe Uplink
Feedback Zone Parameters
Section 3.9.12.2.4
Removed subchannels (changed to vendor
parameter)
February 2010
Configuring Airframe Downlink Data
Zone Parameters
Section 3.9.12.2.5
Removed subchannels (changed to vendor
parameter)
February 2010
Configuring Airframe Uplink Data
Zone Parameters
Section 3.9.12.2.6
Removed subchannels-number (changed to
vendor parameter) and startallocation
(obsolete-hard coded to 0).
permbase is mandatory when creating a new
BS.
February 2010
Restoring the Default Values of
Airframe General Parameters
Section 3.9.12.3.1
Added nbr-beam-forming (new parameter)
and frame-offset
February 2010
Restoring the Default Values of
Airframe Map Zone Parameters
Section 3.9.12.3.2
Added RCID-Usage February 2010
Displaying Configuration Information
for Airframe General Parameters
Section 3.9.12.5.1
Added NeighborBeamForming February 2010
Displaying Configuration Information
for Airframe Map Zone Parameters
Section 3.9.12.5.2
Added RcidUsage February 2010
Displaying Configuration Information
for Airframe Uplink Feedback Zone
Parameters
Section 3.9.12.5.4
Removed subchannels February 2010
Displaying Configuration Information
for Airframe Downlink Data Zone
Parameters
Section 3.9.12.5.5
Removed subchannels February 2010
Topic Description Date Issued