User Manual

Document History
4Motion xxii System Manual
1x1 ODU LEDs
Table 2-3
ETH connector is functional August 2009
Configuring General Neighbor BS
Parameters
Section 3.9.9.2.1
Updated range for frequency August 2009
Configuring the RF Frequency
Parameter
Section 3.9.10.1
Updated range for frequency August 2009
Configuring Bearer Traffic QoS
Marking Rule Parameters
Section 3.9.16.2
Updated range for srvcflow-datadeliverytype. August 2009
Configuring/Modifying the VLAN ID
for an IP Interface
Section 3.4.2.3.5
Added note that after changing the bearer
interface VLAN ID the bearervlanid of all AUs
must be changed to the same value.
August 2009
Restoring the Factory Default
Configuration
Section 3.4.5.4.6
Added note-reset required. August 2009
Restoring the Factory Default
Configuration With Connectivity
Section 3.4.5.4.7
Added note-reset required. August 2009
Deleting Service Flows
Section 3.4.12.11.3.3.7
Corrected range for flow-id August 2009
Configuring ASN-GW Keep-Alive
Parameters
Section 3.4.12.14.1
Corrected command syntax August 2009
Configuring Logging
Section 3.4.13
Added note: Logging configuration reverts to
default after NPU reset.
August 2009
Managing the BS Idle Mode
Parameters
Section 3.9.23
Updated description of the feature. August 2009
IF Cables
Tables 2-1, 2-2
Limitations/Max Length for 3.5 GHz units are
the same as for other ODUs
August 2009
Commissioning
Section 2.1
No need to configure ACL August 2009
Topic Description Date Issued