User Manual
Table Of Contents
- 4Motion System Manual
- About This Manual
- Contents
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 4Motion Solution
- 1.3 The Base Transceiver Station
- 1.4 Element Management Systems
- 1.5 Specifications
- 1.5.1 Modem & Radio
- 1.5.2 Sensitivity (per channel)*
- 1.5.3 ODUs
- 1.5.4 Micro Outdoor BTS
- 1.5.5 AU - ODU Communication (Macro BTS)
- 1.5.6 Data Communication (Ethernet Interfaces)
- 1.5.7 Configuration and Management
- 1.5.8 Standards Compliance, General
- 1.5.9 Environmental
- 1.5.10 Mechanical and Electrical
- 1.5.11 Antennas
- Chapter 2 - Commissioning of the Macro BTS
- 2.1 Initial NPU Configuration
- 2.2 Completing the Site Configuration Using AlvariSTAR
- Chapter 3 - Operation and Administration of the Macro BTS
- 3.1 Using the Command Line Interface
- 3.1.1 Managing the Macro Outdoor BTS
- 3.1.2 Accessing the CLI
- 3.1.3 Command Modes
- 3.1.4 Interpreting the Command Syntax
- 3.1.5 Using the CLI
- 3.1.6 Managing Users and Privileges
- 3.1.7 Managing Secure Shell (SSH) Parameters
- 3.1.8 Managing the Session
- 3.2 Managing Software Upgrade
- 3.1 Using the Command Line Interface
Document History
4Motion xx System Manual
Configuring Airframe Receive
Parameters
Previously Section 4.8.16.2.7
The values are set by internal logic. August 2009
Configuring Antenna Parameters
Section 3.8.2
Updated possible values and default for
antenna-product-id.
August 2009
Configuring Airframe Uplink
Feedback Zone Parameters
Section 3.9.12.2.4
Value of subchannels is set internally
according to bandwidth.
August 2009
Configuring Airframe Downlink Data
Zone Parameters
Section 3.9.12.2.5
Value of subchannels is set internally
according to bandwidth.
August 2009
Configuring Airframe Uplink Data
Zone Parameters
Section 3.9.12.2.6
Value of subchannels-number is set internally
according to bandwidth.
startallocation is hard-coded (value=0).
August 2009
Configuring Airframe MIMO
Parameters
Section 3.9.12.2.7
bcast-msgzone-loc is hard coded (set to
nonSTCzoneOnly).
August 2009
Configuring Ranging Parameters
Section 3.9.19.2
Updated valid values for start-of-rng-codes. August 2009
Managing BS Feedback Allocation
Parameters
Section 3.9.5
Updated valid values for ir-cdma.
The value for max-cqi is set by vendor file.
Updated default value according to
bandwidth.
August 2009
Configuring Power Control Target
Noise and Interference Level
Parameters
Section 3.9.4.2.1
cqi-ack-ranging cannot be modified. August 2009
Configuring the Power Control
Maximum EIRP
Section 3.9.4.2.2
maxeirp cannot be modified. August 2009
Configuring the Power Control
Required C/N Level Parameters
Section 3.9.4.2.2
All parameters cannot be modified. August 2009
Configuring Service Parameters max-subburst is not relevant.
trgt-err-rate cannot be modified.
August 2009
Topic Description Date Issued