User Manual
Table Of Contents
- 4Motion System Manual
- About This Manual
- Contents
- Chapter 1 - System Description
- 1.1 About WiMAX
- 1.2 4Motion Solution
- 1.3 The Base Transceiver Station
- 1.4 Element Management Systems
- 1.5 Specifications
- 1.5.1 Modem & Radio
- 1.5.2 Sensitivity (per channel)*
- 1.5.3 ODUs
- 1.5.4 Micro Outdoor BTS
- 1.5.5 AU - ODU Communication (Macro BTS)
- 1.5.6 Data Communication (Ethernet Interfaces)
- 1.5.7 Configuration and Management
- 1.5.8 Standards Compliance, General
- 1.5.9 Environmental
- 1.5.10 Mechanical and Electrical
- 1.5.11 Antennas
- Chapter 2 - Commissioning of the Macro BTS
- 2.1 Initial NPU Configuration
- 2.2 Completing the Site Configuration Using AlvariSTAR
- Chapter 3 - Operation and Administration of the Macro BTS
- 3.1 Using the Command Line Interface
- 3.1.1 Managing the Macro Outdoor BTS
- 3.1.2 Accessing the CLI
- 3.1.3 Command Modes
- 3.1.4 Interpreting the Command Syntax
- 3.1.5 Using the CLI
- 3.1.6 Managing Users and Privileges
- 3.1.7 Managing Secure Shell (SSH) Parameters
- 3.1.8 Managing the Session
- 3.2 Managing Software Upgrade
- 3.1 Using the Command Line Interface
Chapter 2 - Commissioning of the Macro BTS Completing the Site Configuration Using AlvariSTAR
4Motion 69 System Manual
2 Click Apply for the device to accept the configuration.
3 You will be prompted to properly configure some additional parameters.
4 Click Apply for the device to accept the configuration.
5 Select the Radio Advanced screen and click Apply to complete the
configuration.
2.2.6.3 R6/R8 Bearer Interface
2.2.6.3.1 Bearer Tab
1 Configure the following mandatory parameters:
» IP Address
» IP Subnet Mask
» Default Gateway
2 Enable/Disable ASN-GW Pools
2.2.6.3.2 Authentication Tab
1 Configure the mandatory Default Authenticator IP Address parameter.
2 Click Apply for the device to accept the configuration.
2.2.7 Site Sector Configuration
1 Right click on the Site Sector level entry in the Navigation Pane. The New Site
Sector definition window will open.
2 In the New Site Sector definition window, define the Site Sector Number
3 Click Apply.
To create a new Site Sector entity: